American Power Conversion BH500NET manuals

Computer Equipment > Power Supply

When we buy new device such as American Power Conversion BH500NET we often through away most of the documentation but the warranty. Very often issues with American Power Conversion BH500NET begin only after the warranty period ends and you may want to find how to repair it or just do some service work. Even oftener it is hard to remember what does each function in Power Supply American Power Conversion BH500NET is responsible for and what options to choose for expected result. Fortunately you can find all manuals for Power Supply on our side using links below.

American Power Conversion BH500NET User Manual

4 pages5.83 Mb

INSTALLATION
.apc.com
- to Surge Protection Protection (optional)
- Wiring Fault Indicator
- and Switch on UPS Power
- (optional)
  - 990-9234A 5/07
Back-UPS HS 500
- Users Manual
  - 3Remove Battery (if wall-mounting - if not proceed at Step 5)
  - 1Placement 2Remove Connector Cover
  - 4Mount Back-UPS (optional)
  - 5Connect and Install Battery, Install Battery Cover
  - 6Connect Cable Modem,
  - 7Connect Phone Line
- DSS or CATV Receiver
  - 810 Install Connector Cover
- or DSL to Surge
- Connect Network Equipment
  - 11 Connect to Power Source
- Connect Equipment
  - 9
- Power Cords
  - 12 Check the Building
    - Replace Battery (red)
  - 2S
    - Figure 7. APC Software Startup Menu Selections
    - Figure 3. InstallShield Licence Agreement Screen
    - STATUS INDICATORS AND ALARMS
    - ACT/LNK
    - On Line
    - OverloadOn Battery
      - 5
    - Back-UPS
      - H
    - Replace Battery
    - TX/RX
      - TX/RX (green)
      - ACT/LNK (green)
      - TRANSFER VOLTAGE/SENSITIVITY ADJUSTMENT (Optional)
        Circuit Breaker
        Figure 1. InstallShield Wizard Screen
      - INSTALL AND SETUP SOFTWARE
        Figure 2. InstallShield Welcome Screen
        Figure 4. Choose Destination Location Screen
        Figure 5. Setup Status Screen
        Figure 6. InstallShield Wizard Complete Screen
        
        Figure 8. Back-UPS HS IP Address and MAC Address Screen
- 3Specifications
  - Figure 9. Assign IP Address Screen
  - Figure 10. Blank Assign IP Address Screen
  - Figure 11. Assign Name Screen
  - Figure 12. Manual Reset Access
  - Figure 13. Back-UPS HS 500 Status Screen
  - Figure 14. Log On Screen
  - Figure 15. Maintenance Page Screen
  - Figure 16. Configuration Page Screen
  - Figure 17 About Page Screen
  - Technical Support www.apc.com/support Internet www.apc.com USA and Canada 800-800-4272
- 4Troubleshooting
  - Back-UPS will not switch on
  - Back-UPS does not supply power to network devi ces during an outage
  - Back-UPS operates on battery although norma l utility voltage exists
  - Back-UPS does not provide expected backup time
  - A red indicator is illuminated
  - Red indicators are flashing
  - Replace Battery indicator illuminated / alarm sounds when the unit is turned on
  - ACT/Link Indicator is not illuminated
  - TX/RX Indicators are flashing.
  - Unable to browse to Back-UPS HS
- Order Replacement Battery Warranty Warranty Registration APC Contact Information

Also you can find more American Power Conversion manuals or manuals for other Computer Equipment.