MaxTech 28 manuals

Computer Equipment > Network Card

When we buy new device such as MaxTech 28 we often through away most of the documentation but the warranty. Very often issues with MaxTech 28 begin only after the warranty period ends and you may want to find how to repair it or just do some service work. Even oftener it is hard to remember what does each function in Network Card MaxTech 28 is responsible for and what options to choose for expected result. Fortunately you can find all manuals for Network Card on our side using links below.

MaxTech 28 User Manual

20 pages59.08 Kb

User's Manual
- 1
- 2Section One - Introduction
- Section Two - Installation
  - 2.1 Unpacking Your Modem
  - 2.2 Hardware Installation
  - 32
  - male connector
  - 2.3 Software Installation/Configuration
  - Figure 2-1 Common Serial Ports
  - Figure 2-2 Expansion Slots
  - 43
  - 2.4 COM Port and Interrupt Settings
  - 54
  - Figure 2-3 Switch Block SW1 Location
  - Table 2-1 SW1 Settings
  - 65
  - 2.5 Using the Fax Capabilities of the Modem
  - 2.6 Testing Your Modem After Installation
  - 2.7 Using Your Modem
  - 2.8 Where To Go From Here
  - 6
- 7Section Three - AT Command Set
  - 3.1 Executing Commands
  - 3.2 Command Structure
  - 3.3 Basic AT Commands
  - 98
  - Extended AT Commands
- 11MNP/V.42/V.42bis Commands
- 12Section Four - S Registers
  - 12
  - Table 4-1 S - Registers Register Function Range/units Default
- 13Section Five - Result Codes
  - BASIC RESPONSE CODES
  - 1413
  - EXTENDED RESPONSE CODES
  - 15
- 16Section Six - Troubleshooting
  - Modem does not respond to commands.
  - Modem does not dial.
  - Modem dials but does not connect.
  - 17
- 18Section Seven - Specifications
- Section Eight - Support and Service
- Section Nine - FCC , DOC & Other Notices
  - 9.1 FCC Compliance
  - 1918
  - 9.2 FCC Class B Statement
  - 9.3 DOC Compliance Information
  - 2019
  - 9.4 Disclaimer, Copyright, And Other Notices

Also you can find more MaxTech manuals or manuals for other Computer Equipment.