MAN018 Rev | MaxTech 28, 800 instruction

High Performance

V.34 28,800 BPS

Internal FAX/Data

Modem

User's Manual

	Contents
Section One	Introduction	1
Section Two	Installation	1
Section Three AT Command Set		6
Section Four	S Register Summary	11
Section Five	Result Codes	12
Section Six	Troubleshooting	15
Section Seven Specifications		17
Section Eight	Support And Service	17
Section Nine	FCC, DOC, Copyright And
	Other Notices	17

Part #MAN018 Rev. 1.0

RC288/R6

Image 1

MaxTech 28, 800 user manual MAN018 Rev

Contents

MAN018 Rev Hardware Installation Section Two InstallationSection One Introduction Unpacking Your Modem Software Installation/Configuration Common Serial Ports Male connector COM Port and Interrupt Settings Devices in your computer cannot share an IRQ with SW1 Settings Testing Your Modem After Installation Using the Fax Capabilities of the ModemUsing Your Modem Where To Go From Here Command Structure Executing CommandsBasic AT Commands Bold text Command Function Low speaker volume Commands are echoedTouch-tone dialing DS=n Extended AT Commands Modem is set up for dial-up line operation Guard tone disabledDisable originate-only mode US setting for off-hook-to-on-hook ratio MNP/V.42/V.42bis Commands Section Four S Registers Section Five Result Codes S Registers Function Range/units Default Extended Response Codes Connect 19200/V42BIS Modem does not respond to commands Section Six TroubleshootingModem does not dial Modem dials but does not connect 42bis/V.42/MNP2-5 does not work Modem makes a connection but no data appears on your screenHigh pitch tone is heard whenever you answer the phone Section Nine FCC , DOC & Other Notices Section Eight Support and ServiceFCC Compliance DOC Compliance Information FCC Class B Statement Disclaimer, Copyright, And Other Notices