Main
EW-7438RPn Air
User Manual
III. Browser Based Configuration Interface ................................................. 11
Page
I. Product Information
WPS/Reset Button
LED
Page
II. Installation
1. Plug the EW-7438RPn Air into a power socket. The LED will flash red while
2. Use a Wi-Fi device (e.g. computer, tablet, smartphone) to search for a
3. Open a web browser and if you do not automatically arrive at the Get
4. Please read the on screen instructions about selecting a good location for
5. Select your Wi-Fi network from the list and enter the security
6. Please wait while the EW-7438RPn Air tests the connection.
7. When the connection test is complete, click Apply to restart the
8. Please wait a moment until the extender is ready.
9. A final congratulations screen will indicate that setup is complete. The
10. Please close the browser window. You can now connect to the
1. Press the WPS button on your wireless router/access point to activate its
2. Within two minutes, press and hold the WPS
3. The devices will establish a connection. The extenders LED should display
1. Press and hold the WPS/Reset button for at least 10 seconds until the LED
2. Wait for the extender to restart. The extender is ready for setup when the
III. Browser Based Configuration Interface
1. Enter http://edimaxext.setup into the URL bar of a browser on a network
2. You will be prompted for a username and password. The default username
3. You will arrive at the Status and Information screen. Use the menu
Page
1. After you make any changes to the EW-7438RPn Airs settings, please click
2. Then, select CONTINUE to save changes but not apply them yet, or
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
IV. EdiRange App
1. Open the EdiRange app.
2. Select Management.
3. Enter the username and password (default username: admin default
4. Wait for the app to log in.
Page
Page
Page
V. Appendix
1. Click the Start button (it should be located in the lower-left corner of
2. Obtain an IP address automatically and Obtain DNS server address
Page
1. Click the Start button (it should be located in the lower-left corner of
2. Select Obtain an IP address automatically and Obtain DNS server
Page
Page
Page
Page
Page
Page
Page
Page
Page
Page
1. Click the Start button (it should be located in the lower-left corner of
2. Select Use the following IP address, then input the following values:
Page
1. Click the Start button (it should be located in the lower-left corner of
2. Select Use the following IP address, then input the following values:
Page
Page
Page
6. Select Use the following IP address, then input the following values:
Page
Page
Page
Page
7. Select Use the following IP address, then input the following values:
Page
5. In the IPv4 Address and Subnet Mask field enter IP address
Page
1. Open Control Panel and click on Network and Internet in the top
2. Click on View network status and tasks which is under the heading
3. Click on Manage wireless networks in the left menu.
4. You should see the profile of your Wi-Fi network in the list. Right click on
5. Click on the Security tab, and then check the box labeled Show
1. Open a new Finder window, and select Applications from the menu on
2. Select Passwords from the sub-menu labeled Category on the left side,
Page
Page
1. Go to Start, select Run and type cmd, then press Enter or click OK.
2. A new window will open, type ipconfig and press Enter.
Page
Page
Page
Page
Page
Page
1. Click the network icon ( , or ) in the system tray and select Connect
2. Search for the SSID of your EW-7438RPn Air and then click Connect. If
Page
Page
Page
Page
COPYRIGHT
Federal Communication Commission Interference Statement
EU Declaration of Conformity
Declaration of Conformity