remote control
The D33 is supplied with the CR107 remote control.
English
Using the remote control
Please keep in mind the following when using the remote control:
<Ensure there are no obstacles between the remote control and the remote sensor on the front panel. The remote has a range of about 5 metres. (If the remote sensor is obscured, the IR in remote control input jack on the rear panel is available. Please consult your dealer for further information.)
<Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.
<Replace the batteries when you notice a reduction in the operating range of the remote control.
Inserting batteries into the remote control
1.Open the battery compartment by sliding open the battery cover.
2.Insert two ‘AAA’ batteries into the battery compartment – facing opposite directions, as in the diagram and the battery compartment indication.
3.Slide the battery cover back into place.
Notes on batteries:
<Incorrect use of batteries can result in hazards such as leakage and bursting.
<Do not mix old and new batteries together.
<Do not use
<Ensure the plus (+) and minus
<Remove batteries from equipment that is not going to be used for a month or more.
<When disposing of used batteries, please comply with governmental or local regulations that apply in your country or area.
Alternative code selection
In the rare situation that the CR107 remote control happens to operate another device in the room, the IR code can be changed to an alternative RC5 system number.
To change the remote control to the alternate code:
1.Press and hold the 0 and / keys for 6 seconds until the LED at the top of the remote remains lit.
2.Press OPT2 to select the alternative IR codes (RC5 system code 28) or press OPT1 to select the original code set (RC5 system code 27).
If no key is pressed within 10 seconds the remote will return to normal operation.
Note: the selection of the alternate codes is reset when batteries are changed.
In addition to changing the remote handset, the D33 unit must also be reconfigured to respond to the alternate codes. With the unit powered on, press the Optical 1 and AES/EBU buttons simultaneously. The filter LED will flash to indicate remote code selection. Press the filter button to toggle between the normal IR codes (Filter 1 LED flashing) and the alternative codes (Filter 2 LED flashing). Press any other key to exit the code selection mode.
