321 Studios QW5S, QW2S HOT GAS REHEAT- Factory installed option, CABINET COLOR - Select One

5.12” Fiberglass – Pleated – MERV 8

6.0HOT GAS REHEAT- (Factory installed option)

6.1The dehumidification circuit incorporates an independent heat exchanger coil in the supply air stream in addition to the standard evaporator coil. This coil reheats the supply air after it passes over the cooling coil, and is sized to nominally match the sensible cooling capacity of the evaporator coil. Extended run times in dehumidification mode can be achieved using waste heat from the refrigeration cycle to achieve the reheat process, while at the same time large amounts of moisture can be extracted from the passing air stream.

7.0CABINET COLOR – (Select One)

7.1Washable Vinyl- Two-Tone Finish with Slate front and platinum sides

7.2Slate Gray

7.3Beige

9.0CONTROLS – (Select one of the following factory mounted control options)

9.1None

9.2Electronic non-programmable, manual changeover

9.3Electronic programmable, auto changeover

9.4Electronic programmable, auto changeover, with dehumidistat

9.5Electronic non-programmable, auto changeover, with humidistat

10.0ACCESSORIES

10.1 WALL SLEEVE

Wall sleeve shall be factory supplied and must be constructed of 16 gauge-galvanized steel, coated with an epoxy primer and baked-on polyester enamel paint. It shall be designed to withstand a minimum of 1000 hours of salt spray protection when tested per ASTM B117-03 standard. One sleeve size fits all models. Sleeve only required when a ventilation option is selected.

10.2 Exterior Louver

Furnish factory louver designed for condenser air and outside air

F1915 (2012 04) Page 5 of 6