DUA1840-0AAA01
2-12
C
H
A
P
T
E
R
2:
I
N
S
T
A
L
L
A
T
I
O
N
A
N
D
I
N
I
T
I
A
L
S
E
T
U
P
Using Telnet

Once you have specified the module’s IP parameters, yo u can use any

Telnet application that emulates a VT100 terminal to communicate with

it over the network. To open a Telnet session, specify the IP address of

the Switch 1005. For example:

telnet 191.120.131.6

For further information on using Telnet, refer to the documentation

supplied with the application.

Up to three active Telnet sessions can access the Switch 1005

concurrently. If a connection to a Telnet session is lost inadvertently, the

connection is closed by the Switch 1005 after 2 to 3 minutes of

inactivity.

Using an SNMP Network Manager

Once you have set up the IP parameters of the Switch 1005, you ca n

use any SNMP Network Manager for in-band management, provided

the Management Information Base (MIB) is correctly installed at your

network management station.

3Com provides the Transcend range of SNMP Network Managers, the

use of which is not described in this User Guide; refer to the User

Guides that accompany the software. To manage the Switch 1005 with

a Network Manager from another vendor, you will need to ensure you

have the correct MIB. Contact your local support representative for

advice.