Installing Ethernet Power Source END Devices | 3Com 3C10220 guide

INSTALLING THE

2 ETHERNET POWER SOURCE

AND END DEVICES

This chapter contains the information that you need to install and set up the Ethernet Power Source (EPS) and end devices. The following topics are described:

■Choosing a Suitable Site

■Rack-mounting the EPS

■Power-up Sequence

■Selecting the Correct Cables

■Power Splitter Cable

■Connecting an NBX Business Telephone

■Connecting a 3Com Wireless Access Point

WARNING: Safety Information. Before you install or remove any components from the Power Source unit or carry out any maintenance procedures, you must read the safety information provided in Appendix A of this guide.

AVERTISSEMENT: Consignes de sécurité. Avant d'installer ou d'enlever tout composant du Power Source unit ou d'entamer une procédure de maintenance, lisez les informations relatives à la sécurité qui se trouvent dans l'Appendice A de ce guide.

WARNHINWEIS: Sicherheitsinformationen. Bevor Sie Komponenten aus dem Power Source unit entfernen oder dem Power Source unit hinzufuegen oder Instandhaltungsarbeiten verrichten, lesen Sie die Sicherheitsanweisungen, die in Appendix A (Anhang A) in diesem Handbuch aufgefuehrt sind.

Image 19

3Com 3C10220 manual Installing Ethernet Power Source END Devices

Contents

3Com Ethernet Power Source Guide 3Com Corporation 5400 Bayfront Plaza Santa Clara, California Contents Troubleshooting Conventions About this GuideList conventions that are used throughout this guide Compliance DocumentationComments Year 3Com Support About this Guide 3COM Ethernet Power Source Overview Overview Power source is designed for use with a standardFed through the unused pairs 7/8 and 4/5 Front Panel Connections LEDs 2 Receive on pins 3 LED Behavior 10/100BASE-TX Data and Power Output Ports Test LED Console Port Rear Panel Sample topologies are shown in and Figure Guidelines for Network Configuration 3COM Ethernet Power Source Overview Cabling Patch Panel Laptop with Wireless PCM Card 3COM Ethernet Power Source Overview Installing Ethernet Power Source END Devices Suitable Site Choosing a Repeat and for the other side of the EPS Rack-mountingStandard 19-inch equipment racks Unit, as shown in Figure Installing the Ethernet Power Source and END Devices List the RJ45 input and output plugs per port RJ-45 Input Plug per Port Switch SideRJ-45 Output Plug per Port DTE NIC Side Cable Power SplitterData 3Com Wireless Ethernet Power SourceAccess Point Wiring Closet Patch Panel Premises Installing the Ethernet Power Source and END Devices Problems TroubleshootingSolving EPS Solving EPS Problems Solving EPS Problems Telephone To resolve the problemSolving NBX Business Telephone Problems Solving NBX Solving NBX Telephone Problems Solving Wireless Access Point Problems Wiring, hubs, and switches Troubleshooting Safety Information Connected to an earthed grounded outlet Important SafetyConnect it to an AC outlet power supply Information Sécurité Importante ’information de Sécurité Importante France et Pérou uniquement Heitsinformationen Wichtige Sicher Appendix a Safety Information PIN Assignments Technical Specifications for the Ethernet Power Source Pin Assignments Pin Number Signal Function 3Com Corporation Limited Warranty Warranties Exclusive