3Com 3CR990-TX-95, 3CR990-TX-97 Installing From Diskette, Making a DOS-Bootable Diskette

Installing From Diskette 5

This guide explains installing network drivers from floppy diskettes for the 3Com® EtherLink® 10/100 PCI network interface card (NIC) with 3XP processor (3CR990 family). It is intended to be used with computers that are not equipped with a CD-ROM drive.

For complete instructions about EtherLink 10/100 PCI NIC hardware installation, configuration, and troubleshooting, see the EtherLink 10/100 PCI Network Interface Card with 3XP Processor User Guide (P/N 09-1742-001).

You can print the Adobe Acrobat Reader Portable Document Format (PDF) version of this guide for reference. It is available on the EtherCD™ in the following location:

\english\manuals\etherdsk\usrguide.pdf

Installing From Diskette

If your computer does not have a CD-ROM drive, use a PC that has a CD-ROM drive and create installation diskettes from the EtherCD.

You can also download the EtherDisk software from the 3Com World Wide Web site:

http://support.3com.com/infodeli/tools/nic

The installation diskettes allow you to install the network driver only. If you want to install the NIC diagnostics or desktop management software, you must install them from the EtherCD.

Making a DOS-Bootable Diskette

For installation and configuration procedures that require you to boot from DOS, you cannot successfully use the MS-DOS prompt from within Windows. Perform a “clean” boot from DOS or use a DOS boot disk.

To use the CD-ROM drive on a PC or server in a DOS environment, the DOS drivers for the CD-ROM drive must be installed. Consult the documentation that accompanied your CD-ROM drive or your motherboard for information about how to install these drivers.

If the PC or server is only running DOS and a CD-ROM drive is not installed, you must install the NIC software