13.Lower the cart assembly to rest upside down on its top flanges, with wheel support up. See figure 11.

14.Assemble latch lock subassembly to drawbar tongue using two 1/4" x 5/8" long hex bolts, lock washers and hex nuts. Tighten. See figure 9.

1/4" x 5/8"

LATCH LOCK HEX BOLT SUB-ASSEMBLY

DRAW BAR

TONGUE

1/4" x 1-3/4"

HEX BOLT

1/4" LOCK WASHER

1/4" HEX NUT

AXLE

DRAW BAR

TONGUE

WHEEL

SUPPORT

1/4" LOCK

WASHER

1/4" HEX NUT

FIGURE 9

15.Assemble hitch bracket to drawbar tongue, using two 3/8" x 1" hex bolts, 3/8" lock washers and 3/8" hex nuts. See figure 10.

TONGUE

 

3/8" x 1"

 

HEX BOLT

 

 

 

 

 

 

 

 

3/8" LOCK

WASHER

3/8" HEX NUT

FIGURE 10

16.Assemble axle and drawbar tongue to wheel sup- port keeping the open side of tongue facing away from cart. Make sure the latch lock snaps over the top of latch stand bracket. Secure axle to wheel support using two 1/4" x 1-3/4" hex bolts, lock washers and hex nuts. See figure 11.

FIGURE 11

17.Assemble a spacer tube, a 1" flat washer, a wheel with the valve stem facing out, and another 1" flat washer onto the axle as shown in figure 12. Se- cure with a cotter pin and spread ends so that hub cap can fit over the cotter pin . Assemble the hub cap by pressing it onto the flat washer. Repeat for other end of axle.

WHEEL

AXLE

1" FLAT

 

WASHER

1" FLAT WASHER

SPACER TUBE

HUB CAP

COTTER PIN

 

FIGURE 12

18.Turn cart over so that it rests right side up on its wheels.

5