19.To mount the tool holder brackets to the front of the cart it will be necessary to drill four holes in the front panel of the cart. (Recommended hole size is 9/32" diameter.) The tool bracket holders may be used to locate hole positions by placing the bracket against the front panel and marking the hole loca- tions onto the front panel. The top tool holder bracket should be positioned equally from each side of the cart and even with the top edge of the front panel. The bottom tool holder bracket should be positioned equally from each side of the cart with the top of the bracket approximately six inches up from the bottom. See figure 13.
20.Press the protective edging strips over the top edge of both tool holder brackets. Mount the tool holder brackets on the inside of the front panel of the cart using four 1/4" x 1/2" hex bolts, 1/4" lock washers and 1/4" hex nuts. See figure 13.
1/4" HEX NUT | 1/4" LOCK | TOOL HOLDER | |
WASHER | BRACKET | ||
| |||
|
| 1/4" x 1/2" | |
|
| HEX BOLT |
FIGURE 13
21.Place the tailgate down into the tailgate guides so that the holes in bottom lip of tailgate fit over heads of slotted head screws in bottom of cart. This completes the assembly of your cart.
6