3Com 6000 manual The banner varies by Boot ROM version, Checking/Operating after power-on

34Chapter 3: Starting and Configuring the Router 6000

Checking/Operating after power-on

After powering on the router, check that:

■The LEDs on the front panel show that the router is operating normally.

For description on LED behaviors, refer to the section “Generic Modules”.

■The console terminal displays normally.

After you power on the router, you can see the startup banner (refer to the section “Boot Process of the RPU2”). After the boot process or power-on self-test (POST) completes, press <Enter> as prompted and proceed to configure the router when the command line prompt <3Com> appears.

Boot Process of the The Boot ROM runs at startup of the router. The terminal displays the RPU2 following banner:

The banner varies by Boot ROM version.

System starts booting ... (1.01)

*******************************************

*	*
*	3Com 6000 Router, 10.05 *
*	*

*******************************************

Copyright© 2003-2004 by 3COM-3COM TECH CO., LTD.

Compiled	at Wed Jul		20 16:35:23 EDT 2005
Testing memory...OK!
512M bytes SDRAM		Memory
Hardware	Version	is	2.0
CPLD	Version	is	1.0

Press Ctrl-B to enter Boot Menu 0

Press <Ctrl+B> to have the system enter Boot Menu. Otherwise, the system starts decompressing the program and displays:

System is self-decompressing......................................

OK!