Installation procedure

The worktop must be completely level.

Protect the cut-out surfaces.

Screw on the support elements provided using the respective screws on the front and rear end of the cooker hob (already configured with the relative holes and slots).

Connect the cooker hob to the mains electricity (consult the connection instructions).

Position the cooker hob in the cut-out.

Press it forcefully agianst the worktop.

Applying the sealant

The picture indicates how the sealant must be applied along the entire edge.

CONNECTION TO THE MAINS ELECTRICITY

The electrical connections must be carried out by qualified personnel only. The electrical connection must be protected in accordance with the regulations in force.

The connectors are accessible when the wires cover is opened.

Prior to connecting the appliance, verify that the voltage indicated on the rating plate complies with the mains voltage.

The rating plate of the glass-ceramic hob is located on the underside.

The appliance operates at 220-240V AC ~ (or, alternatively, at 380-415 V 2N~).

In the direct connection to the mains electricity, an omnipolar switch with a contact gap of 3 mm - suitably sized for the load and conforming to the regulations in force - is positioned between the appliance and the power outlet.

The type of electrical connection must be chosen according to the available installation options for the electric current and overload safety switches.

To ensure protection against fire, appliances of this kind can be installed between a taller cabinet on one side and a cabinet of equal height (as the appliance) on the other side.

For safety reasons, electrical connection components and insulated parts must not be accessible.

If the model is not equipped with a plug, mount a standardised plug on the power cord capable of withstanding the load indicated on the rating plate. The earth wire is identified by the yellow/green jacket. The plug must always be accessible.

Basic configuration of the sensors to the environment

(for model "7316-000" only)

After each connection to the mains electricity, basic configuration of the sensors must be carried out to ensure their optimal operation. All the displays turn on for a few seconds. There must be no objects on the hob surface during sensor configuration. Otherwise, the configuration

25

Page 12
Image 12
3D Innovations 7316-000, 7352-010 Installation procedure, Applying the sealant, Connection to the Mains Electricity