
Pipettor Programming
The Program Menu
1. The following five dilutions have been
| Dilution | Diluent | Sample | Total |
Mode | Ratio | Volume | Volume | Volume |
d1 | 1:5 | 4.00mL | 1.00mL | 5.00mL |
d2 | 1:10 | 4.50mL | 0.50mL | 5.00mL |
d3 | 1:20 | 4.75mL | 0.25mL | 5.00mL |
d4 | 1:5 | 0.80mL | 0.20mL | 1.00mL |
d5 | 1:10 | 0.90mL | 0.10mL | 1.00mL |
2. Repeat Dispense 1mL Mode-
This mode performs repeat 1mL dispensing.
Mode Volume Repetitions
rd1.00mL
3. Pipette Modes -
These modes perform standard 1mL and 5mL pipetting with
Mode Volume
P1 1.00mL
P5 5.00mL
4. Open Dilution Mode -
This mode allows selection of any dilution ratio within the range of the pipettor
|
| Diluent | Sample | Max. |
|
| Volume | Volume | Total |
Mode | Increment | Range | Range | Volume |
d0 | 0.05mL | 5.00mL |
Page 4 of 15 - June 2001
Pipettor Programming
Power “ON” Display and Startup
The display of a switched “ON” pipettor indicates that programming has been reset to default settings.
1.Switch the unit “ON”. Display:
2.Press the Start Button twice. The display shows that the unit is ready for the default 1:5 dilution (Mode d1, 5mL) or for program changes.
Switching the pipettor “OFF” and then “ON” will reset the unit to the default settings (Mode d1, 1:5, 5mL dilution).
Mode Selection and Mode Recall
Selecting available modes on the pipettors is done with the use of these three keys:
1.Press once to display the default dilution mode of the pipettor.
2.Press repeatedly to view each of the modes available.
3.Press when the desired mode is displayed. This will enter the mode selection and allow you to use this mode.
Mode recall allows you to flip back and forth between the last two modes used.
or
may not be used in the middle of an aspiration or dispensing cycle.
7 | 8 |