3M 2210 manual Receiver Operation, Battery Installation, Receiver Front Panel

Receiver Operation:

Battery￿ Test

Ind￿cator

Battery Level￿ Mark

Receiver Front Panel

DynatelTM

2210
577 Hz	33 KHz

On

Off			Hz
	Gain Adjust	Depth	Freq

1.Press to turn receiver on and see battery level. Hold down for continuous Battery Test. If bar graph is to the left of the battery level mark, replace batteries. Note: when

batteries are low, the battery test indicator remains on.

2.Press to match Frequency to transmitter output or select for passive power locating.

3.Press to set Gain when bar graph is not visible or is closed. For High Volume (),

hold down while turning unit on. To return to normal volume, turn unit off, then on again.

4.Make broad sweeps with receiver handle in line with target cable path to get maximum bar graph closure; press . Maximum bar graph and numeric indication occurs directly over cable.

5.Place the receiver upright on the surface directly over cable. With handle parallel to

path, press to display estimated Depth. Press again to display numeric Current

indication. Cable with highest current indication is the target. Press to return to trace mode, and press . Unit returns to trace mode automatically after eight seconds.

Note: Active Duct Probe (sonde) depth will differ from cable depth due to the shape of the electromagnetic field of the ADP. Conversion tables are provided with the ADP to obtain accurate depth estimates.

Battery Installation

6 `C' cells

6 `AA'

cells

3