Direct Wire Installation: Copper or Aluminum Wire
This range may be connected directly to the fuse disconnect or circuit breaker box. Depending on your electrical supply, make the required
1.Strip outer covering back 3" (7.6 cm) to expose wires. Strip the insulation back 1" (2.5 cm) from the end of each wire.
1"
(2.5 cm)
3"
(7.6 cm)
2.Allow enough slack in the wire to easily attach the wiring terminal block.
3.Complete electrical connection according to your type of electrical supply
4-wire Connection: Direct Wire
Use this method for:
■New
■Mobile homes
■Recreational vehicles
■In an area where local codes prohibit grounding through the neutral
1.Remove the
C
B
A
A.
B.Cup washer
C.
2.Connect the bare ground wire to the range using the ground- link screw and cup washer. The ground wire must be attached first and must not contact any other terminal.
D
C
E
F
B
AG
A. Bare wire from power supply | E. Line 2 |
cable | F. Neutral (white) wire |
B. Line 1 | G. UL listed conduit connector |
C. Hex washer head screw | and power supply cable |
D. |
|
screw |
|
3.Loosen (do not remove) the hex washer head screw and insert the neutral (white) wire under the screw clamp at the bottom of the center position terminal connector.
4.Insert the other 2 wires (lines 1 and 2) under the other 2 screw clamps.
B
A
A.Insert wire under screw clamp.
B.Hex washer head screw
5.Securely tighten the hex washer head screws to
35
6.Tighten the locking ring of the conduit connector.
7.Replace the terminal block cover.
12