3M 2600 manual Cleaver Operation

5.03Lay the stripped ribbon between the guide forks. The ribbon should be positioned so that 1" to 2" (25 mm to 51 mm) of unstripped ribbon extends beyond the end of the holder.

5.04 Place the cover over the ribbon and snap into place.

6.0 Cleaver Operation

6.01The Alcoa Fujikura Model CT-03, CT-04, CT-04B, or CT-07, is required for the cleaving process.

Note: Sumitomo Model FC-4 Cleaver may also be used, along with the 2651-A Fiber Viewer.

6.02If present, the guide plate must be removed so that the cleaver spacer gauge assembly can be installed. Remove the screws that secure the guide plate. Remove the guide plate.

6.03Install the cleaver spacer gauge in the slot. The spacer should be snug against the wall near the rubber pad.

9