10
Installation and Set-Up (Continued)
WARNING – Keep hands/fingers
away from tape cut-off blade under
orange blade guard. Blade is extremely
sharp and can cause severe injury.
Push buffing roller into head to check for free,
smooth action of taping heads.
12. Ensure that the tape drum bracket assembly,
located on the lower taping head, is mounted
straight down, as shown in Figure 2-2A. The
tape drum bracket assembly can be pivoted to
provide tape roll clearance in certain cases.
13. Remove fasteners that secure case sealer legs
to pallet.
11. Check for free action of both upper and lower
taping heads.
Figure 2-1 – 700a Frame Set-Up
14. Use appropriate material handling equipment
to remove the machine from the pallet and
move it into position.
Whenever the machine is lifted with a fork
truck, insure that the forks span completely
across the machine frame and do not contact
any wiring or mechanism under the machine
frame. In some cases the lower taping head
may need to be removed to avoid damage.
CAUTION – Machine weighs
approximately 160 kg [350 pounds]
uncrated.
15. Continue with the remainder of the Installation
and Set-Up procedure through page 12.