15
Figure 3-4 – Side Guides
Figure 3-2 – Upper Taping Head
Figure 3-3 – Upper Taping Head
2. ADJUST SIDE GUIDES (Figure 3-4)
Align box top flap center seam with arrows on
front of ski.
Move side guides against each side of box to
hold box in position, centered on arrows on front
of ski.
Tighten hand knobs to secure side guides.
Operation (Continued)
Box Size Set-Up
1. ADJUST UPPER TAPING HEAD
The upper taping head is positioned for the box
height by means of the height adjustment crank
shown in Figure 3-2. Turn crank clockwise to
lower head, counterclockwise to raise head.
Move the top flap compression rollers to a
position wider than the box.
Place box on infeed end of machine bed with
both top and bottom flaps folded and insert
under upper head ski approximately 150 mm
[6 inch] as shown in Figure 3-3. Lower the head
until all flaps are fully closed. Align box top flap
center seam with arrows on front of upper frame.