Check the 3MTM Bair PawsTM system website to ensure you have the most recent version of this document.

www.bairpaws.com reorder #202391A

Preparing the Bair Paws Model 875 Warming Unit for Use

Before you begin using the warming unit, make sure that it is safely placed on a flat, hard surface such as a table, or securely mounted on a wall, IV pole, suction wall mount adapter, or bedrail.

CAUTION: Do not place the warming unit on a soft or uneven surface, such as a bed; this may cause the air intake to become blocked, compromising the unit’s performance.

A wall-mount bracket is shipped with every warming unit; the brackets for mounting the warming unit to an IV pole, bedrail, or a suction wall mount adapter are available separately. Please contact your local sales representative or call 3M patient warming customer service at 1-800-228-3957 for more information about ordering mounting brackets and adapter.

The following instructions for mounting the warming unit assume that the brackets have already been attached to the wall or to the warming unit.

Placing the Warming Unit on the Wall-mount Bracket

1.Snap the warming unit into position by sliding the clip on the back of the warming unit into the groove of the wall-mount bracket. The assembly will click when the clip is fully seated in the wall-mount bracket.

2.Lift the warming unit straight up to remove it from the wall-mount bracket.

Note: It may be necessary to gently strike the case bottom in an upward fashion with the palm of your hand to release the clip from the wall-mount bracket.

Wall-mount bracket

Case bottom

7

English  202391A