Programming the System | 3M Model |
Programming the Selector
Programming State
1 
2 
3
4 
5 
6
7 | 8 | 9 | T | |
A | ||||
|
|
| ||
| MENU |
| L | |
| 0 |
| K |
Figure 5. D-2400 Keypad
To program the
To enter the programming state, simultaneously:
Press and hold the STD BY key.
Enter the numeric code: 97531.
The display shows:
01:Selector ID # {01}
The Parameter #, Parameter Name/Value, and Parameter Value fields are as shown below.
| Parameter |
Parameter # | Name/Value |
↓ | ↓ |
01:Selector ID # {01}
−
Parameter Value
The _ indicates cursor position. To move the cursor from one field to another, use the Left Arrow and Right Arrow keys.
To input data at the cursor position, do one of the following:
∙Use the Up Arrow and Down Arrow keys to scroll to desired value.
∙Use the 1, 2, 3, 4, 5, 6, 7, 8, 9, 0/Menu keys.
The STD BY key clears a field to a default value (space for text or the default value).
The HOLD key shifts case for text data.
The ALL CALL key exits from the programming state and enters the Off Line mode.
!Important
All Selectors ship from the factory with a default ID number of 15. It is important to connect and power up each new selector, ONE SELECTOR AT A TIME, when installing a new system. Doing this allows you to change the ID number to a lower value (start at 1) and avoid the erratic behavior caused by multiple selectors sharing the same ID number.
8
