3M™ Pocket Projector MP180
Installing and Charging the Projector BatteryRemoving the Protective Film
When the projector is shipped, there is a protective film between the battery and the battery contacts on the projector. Remove the protective film by removing the battery and the protective film, discard the film and finally install the battery.
Install Battery
The 3M projector comes with a rechargeable battery. The battery should be fully charged before using the projector with the battery.
To install the battery, orient the contacts on the battery toward the contacts on the projector, insert the end farthest from the battery latch first, then push down until the battery clicks into place. The projector will automatically turn on.
Remove Battery
To remove the battery, slide the battery latch away from the battery and then lift the battery out, starting at the end closest to the latch.
English
Important Note: Use only the
Note: The projector will turn on automatically when the battery is installed.
© 2011 3M. All Rights Reserved. | 11 |