3M MP7750 Turning Off The Power, Press the STANDBY/ON button control, panel or remote control

TURNING OFF THE POWER

LASER

INDICATOR

STANDBY/ON VIDEO RGB

	UP
FOCUS ZOOM	PAGE
	DOWN
BLANK	LASER

ASPECT

PUSH

ENTER

ESC MENU RESET

POSITION AUTO PinP

MAGNIFY	VOLUME
ON
FREEZE	MUTE
OFF
WIRELESS KEYSTONE	ONE TOUCH

Control panel

1	Press the STANDBY/ON button (control
	panel or remote control)
	The message "Power off?" will appear on the screen for	STANDBY/ON
	approximately 5 seconds.

2	Press the STANDBY/ON button again
	(control panel or remote control)

Press the STANDBY/ON button again while the "Power off?" message is visible. The projector lamp goes off and starts cooling down. While cooling, the STANDBY/ON indicator flashes orange. When in this state, pressing the STANDBY/ON button has no effect.

When lamp cooling is complete, the STANDBY/ON indicator stops flashing, and turning solid orange.

STANDBY/ON

3	Check that the STANDBY/ON indicator
	stops blinking and lights to	power switch
	solid orange.
	Switch the power switch to
	[O] (OFF).

STANDBY/ON indicator

NOTE

•Except in cases of emergency, do not turn off the power switch while the STANDBY/ON indicator is solid or flashing green. Doing so could shorten the lamp lifetime.

4	Confirm that the STANDBY/ON indicator has
	gone off and then attach the lens cap.

When the projector has completed powering down, the STANDBY/ON indicator will go off.

17