3M™ Multimedia Projector MP8755/MP8755L/MP8770/MP8770L
© 3M 2000
ENGLISH
12
1. Make all cable connections and line hookups with the power off.
2. Turn on the projector’s MAIN POWER SWITCH
OI
. The POWER indicator will light up orange.
3. Press the STANDBY/ON button
STANDBY ON
. The POWER indicator blinks (green) and then lights (green).
The POWER indicator will blink green during warm-up and lamp ignition. When power is turned off,
there is a 60 second reset period before the STANDBY/ON button will function again.
4. Adjust the screen size by pressing the ZOOM button.
+
–
ZOOM
5. Adjust the focus by pressing the focus button.
+
–
FOCUS
Press any other button to make the focus screen disappear.
6. Turn on all connected equipment. Refer to Section 2.3.
7. Press the INPUT button
INPUT
on the projector or the INPUT SELECT (VIDEO or RGB) button on the
remote to select the source of the signal to be projected on the screen. The selected signal input is
displayed at the bottom right of the screen. The display will show the last selected input source before
power was turned off.

3.2 Projector Shutdown

1. Press and hold the STANDBY/ON button
STANDBY ON
for 1 second. The POWER indicator blinks orange and the lamp turns
off. After approximately 1 minute, the fan stops and the indicator stays orange.
2. Turn off the projector’s MAIN POWER SWITCH
OI
.
3. Attach lens cap to protect projection lens.
4. Disconnect cables if moving projector to new location.
Section 3: Basic Operations
Figure 3.1 Projector Controls

3.1 Projector Startup

Caution
MP8770
+
ZOOM
MUTEINPUT
STANDBY ON
RESET
POWERLAMPTEMP
MENU
+
FOCUS
MP8770
PORTABLE PROJECTOR
OI
+
ZOOM
MUTE INPUT
STANDBY ON
RESET
POWERLAMP TEMP
MENU
+
——
FOCUS
EPS-130A
Do not turn off the MAIN POWER SWITCH before pressing the STANDBY/ON button. After the STANDBY/ON button is
pressed, the fan rotates for about 1 minute to cool the projector.