Enviro C-11150 technical manual stove, Straight through wall Installation

Installation

HORIZONTAL EXHAUST THROUGH WALL INSTALLATION:

Vent installation: install vent at clearances specified by the vent manufacturer.

A chimney connector shall not pass through an attic or roof space, closet or similar concealed spaces, or a floor, or ceiling. Where passage through a wall or partition of combustible construction is desired, the installation shall conform to CAN/CSA-B365 Installation Code for Solid-Fuel-Burning Appliances and Equipment. Only use venting of L or PL type with an inside diameter of 3 or 4 inches (7.6 or 10.1 cm).

1.	Choose a location for your stove that meets
	the requirements stated in this manual and									Wall
	allows installation with the least amount of
									4"	thimble
	interference to house framing, plumbing,
									(10 cm)	12"
	wiring, etc.
										(30.5 cm)
2.	Install a non-combustible hearth pad
	(where necessary).
3. Place the appliance 15” (37.5 cm) away
	from the wall. If the stove is to be set on									45°
	a hearth pad, set the unit on it, and adjust							6"		elbow
	the leveling legs.
4.	Locate the center of the exhaust pipe on							(15 cm)
	the stove. Extend that line to the wall.									Rodent
	Once you have located the center point on									mesh cap
	the wall, refer to pellet vent manufacturer
	installation			instructions		for	correct hole	Non-combustible	Existing floor
	size and clearance to combustibles.
								floor protection.	(combustible)
5.	Install the wall thimble as per the
								Figure 11: Straight through wall Installation.
	instructions written on the thimble.
	Maintain an effective vapour
	barrier		in	accordance		with
	local building codes.
6.	Install a length of 3” (75
	mm) or 4” (100 mm) vent
	pipe into the wall thimble.
	The pipe should install easily							Exhaust Tube
	into the thimble.
									3" (75mm) or 4" (100mm) "PL" or "L" vent
7.	Connect			the	exhaust
	vent pipe to the exhaust								Wall Thimble
	pipe	on		the	stove.	Seal
	the	connection			with	high
	temperature silicone.
8.	Push the stove straight back,									45° Elbow with screen or
	leaving a minimum of 4” (10						Fresh Air Intake Tube			Termination Cap
	cm) clearance from the back
	of the stove to the wall. Seal
	the vent pipe to the thimble
	with		high		temperature			High Temperature RTV
	silicone.							Silicone Required
							Figure 12: Venting to use with straight through wall Installation.

12