Preparations

About the filter cover for bottom-up use

WARNING ►Do not replace the filter cover and/or air filter during use or immediately after use. Handling while the projector is in a high temperature could cause a burn and/or malfunction to the projector. Before operating, make sure that the power switch is off, that the power cord is not plugged in, and that the projector is cool adequately.

When the projector is installed bottom up, please use the accessory filter cover for bottom-up use. It is higher than usual filter cover, to keep the space for intake ventilation. Please change in the following procedure.

1. Disconnect all the connectors and adapters that were connected to the projector’s ports. Then slowly turn the projector so that the lens-side is facing

up. Please be careful for a projector not to fall. While the projector is placed lens-side up, hold the projector.

2. Remove the filter cover and the air filter. Hold the knobs while pulling out it.

Filter cover’s knob

Air filter’s knob

3. Slowly turn the projector so that the bottom is facing up.

4. Set a new or cleaned air filter to the filter cover for bottom-up use. Make the claws slide along the rail, and set the air filter into place.

Claws

Air filter (New or cleaned)

Rail of air filter

 

Filter cover for bottom-up use

5. Interlocking the tabs, snap the filter cover for bottom-up use into place.

Tabs

Filter cover for bottom-up use

 

(with an air filter)

9

Page 9
Image 9
3M X15 manual About the filter cover for bottom-up use