Part names
Part names
Projector |
| Remote sensor ( 15) |
|
| |
Zoom knob ( 18) |
| Speaker |
Focus ring ( 18) |
|
|
Vent ( 6) |
| Elevator button ( 8) |
|
| |
Lens ( 16) | Elevator foot ( 8) | |
Lamp door (45) |
| Filter cover ( 46) |
| (Air fi lter and intake vent | |
(Lamp unit is inside.) |
| are inside.) |
| Bottom side |
|
Control buttons (5) |
|
|
(See the following page.) |
|
|
Ports (See below.) |
| Elevator button ( 8) |
AC inlet ( 13) |
| Elevator foot (8) |
|
| |
Power switch ( 16) |
| Vent (6) |
| ||
|
|
DC OUT port USB port (11)
COMPONENT VIDEO ports (12)
Y
CB/PB
CR/PR
LAN port (12)
|
|
| RGB IN1 |
LAN |
|
| |
USB | DC OUT |
|
|
| COMPONENT VIDEO | RGB OUT | |
|
| ||
| CR/PR | CB/PB | Y |
| VIDEO |
Restart switch (*) (52)
RGB IN1 port (11)
RGB IN2 |
| |
| RGB IN2 port (11) | |
| REMOTE | AUDIO OUT port (11) |
CONTROL | CONTROL |
|
AUDIO IN port (11)
AUDIO IN L/R port (12)
VIDEO port (12) | Ports |
WIRED REMOTE port CONTROL port (11) RGB OUT port (11)
NOTE (*) About Restart switch: This Projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar, and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.
4