Using the Monitor
Pairing / Unpairing
A Bluetooth device needs to be paired with a different specific device in order to communicate with that device. If this monitor is paired with a receiver device from the start, measurement data is transmitted automatically to the receiver device each time a measurement is made.
Unpairing needs to be performed to cancel pairing.
Cautions for pairing
Be sure to turn the power of all other Bluetooth devices off when pairing. Multiple devices cannot be paired at the same time.
If the receiver device cannot receive measurement data, try pairing once again
Two receiver devices can be paired to one monitor. Communication is possible with one of the receiver devices.
If a third receiver device is paired, the device other than the most recently connected device will be unpaired to enable the new device to be paired.
Some applications may allow pairing with only one device.
Follow the steps below to pair or unpair the monitor with a Bluetooth compatible receiver device. Also refer to the manual of the receiver device. Please use a pairing wizard if one is provided.
Pairing procedure
1.Follow the instructions in the manual of the receiver device to switch it to the pairable status. When pairing this monitor, place it as close as possible to the receiver device to be paired with.
2.Install the batteries or connect the AC adapter as
described on page 6. The monitor displays “pr”.
The monitor will be in a state that can be found by the receiver device for about two minutes.
3. The monitor displays “end” to indicate that pairing is complete.
4.If “err10” is displayed or pairing is failed, remove the batteries or disconnect the AC adapter and try steps
5.Follow the manual of the pairing receiver device to search for, select and pair with this monitor.
If a PIN code is requested by the receiver device, enter "39121440".
English 8
