Applying the Arm Cuff, How to Take Proper Measurements

Using the Monitor

Applying the Arm Cuff

1.Wrap the cuff around the upper arm, about 1-2 cm above the inside of the elbow, as shown.

Place the cuff directly against the skin, as clothing may cause a faint pulse, and result in a measurement error.

2.Constriction of the upper arm, caused by tightly rolling up a shirtsleeve, may prevent accurate readings.

3.Confirm that the index points within the proper fit range.

Do not roll up shirtsleeve tightly

Cuff

1 to 2 cm

Artery position mark

Secure the fabric

fastener firmly

Air hose

Index and Proper fit range

For the most accurate blood pressure measurement:

Sit comfortably on a chair. Rest your arm on the table. Do not cross your legs. Keep your feet on the floor and straighten your back.

Relax for about five to ten minutes before measurement. Place the center of the cuff at the same height as your heart.

Remain still and keep quiet during measurement.

Do not measure immediately after physical exercise or a bath. Rest for twenty or thirty minutes before taking the measurement.

Try to measure your blood pressure at the same time every day.

During measurement, it is normal for the cuff to feel very tight. (Do not be alarmed)

After measurement, press the START Remove the cuff and record your data.

button to turn off the power.

Note: The device has an automatic power shut-off function, which turns the power off approximately one minute after measurement.

Allow at least three minutes between measurements on the same person.

English 11