5
final installation
The speaker is held in place with four mounting clamps that are part of the assembly. When
shipped from the factory the clamps are pivoted so they will fit into the mounting hole. When
the mounting hole clamp screws are turned, the clamps pivot outward and are then drawn
downward until they press against the back of the mounting surface.
Insert the speaker/mounting bezel assembly into the mounting hole. Hold the speaker in place
in the mounting hole and evenly tighten the four mounting screws to draw the mounting
brackets against the backside of the wall. Gradually tighten the screws, moving from one to
another, until the speaker is firmly clamped in place.
custom painting
• Paint the speaker frame and grill before mounting to the wall; paint grill and frame separately.
• Before painting, mask the recessed area of the speaker to completely protect the speaker
drivers.
• After painting the grill, gently blow through its perforated holes to prevent paint clogging.
operation
checking the system
Listen carefully to each speaker. If you hear buzzing or rattling noises, remove the speaker and
check for a speaker wire(s) or other objects touching the speaker assembly. When you are
satisfied with the installation press the grills into place.
tweeter protector
If a speaker sounds "dull", or "lacks "brilliance", you may have activated the tweeter protector.
If high power operation causes the tweeter to stop playing, turn down the volume control until
normal sound resumes.