Cisco Systems OL-6256-17 manual Installing an MSC

Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components

How to Install or Remove an MSC, FP, or LSP

Figure 4-23 Installing an MSC

1

2

3

122922

1 Captive screw 3 Direction of installation or removal

2Ejector lever

Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket on the rear (MSC) side or a bare metal surface on the chassis.

Step 2 Choose an available MSC slot for the MSC.

Caution To prevent ESD damage, handle a line card by its ejector levers or the card carrier edges only. Do not touch any of the electrical components, pins, or circuitry.

Step 3 Remove the MSC impedance carrier from the slot you need to fill and set it aside.

Note Remove only one impedance carrier and install one MSC at a time. Be sure to verify that each line card is fully installed and secured before installing another card.

Step 4 Remove the line card you are installing from its antistatic packaging.

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

4-32 OL-6256-17