Cisco Systems OL-6256-17 manual Removing a Slot Cover, Switch Fabric Slot Half Height Slot Cover

Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components

How to Install or Remove a Slot Cover

Step 3 Partially tighten the four captive screws on the front panel of the slot cover (either by hand or with the screwdriver) to make sure that they are both engaged.

Step 4 To seat the slot cover firmly in place, fully tighten the captive screws.

What to Do Next

After performing this task, replace any rear (MSC) side cosmetic covers.

Removing a Slot Cover

This section describes how to remove a slot cover from the Cisco CRS 8-slot line card chassis. The chassis is shipped with slot covers over the switch fabric card and RP card slots. Both slot cover types are removed in the same manner. (Figure 4-13shows a switch fabric slot cover for reference.) For more detailed information on the slot covers, see the “Information About Impedance Carriers and Slot Covers” section on page 4-6.

Figure 4-13 Switch Fabric Slot (Half Height) Slot Cover

122142

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

OL-6256-17 4-15