Chapter 2 Installing and Removing Power Components

How to Install or Remove Modular Configuration Power Components

Removing Modular Configuration AC Power Shelf Wiring

This section describes how to remove input AC cords from the modular configuration AC power shelf.

Prerequisites

Before performing this task, power down and remove AC PMs in the shelf you want to disconnect.

Note Before removing wiring from the power shelf, make sure that the input power cables are not energized.

Required Tools and Equipment

You need the following tools to perform this task:

6-in. long number 1 Phillips screwdriver

Note You can use an offset number 1 Phillips screwdriver to tighten the AC cord clamp that was available pre-June 2011, but this is optional. An offset screwdriver is not required to tighten the AC cord clamp that is available from June 2011 onwards. See Figure 2-36.

Steps

To remove the input AC cords, go to the rear of the chassis and perform the following steps:

Step 1 Use the screwdriver to loosen the screw that clamps the cord in place, see Figure 2-36. Step 2 Remove the cord from the cord clamp, as shown in Figure 2-36.

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

 

OL-6256-17

2-47

 

 

 

Page 79
Image 79
Cisco Systems OL-6256-17 manual Removing Modular Configuration AC Power Shelf Wiring