
Chapter 2 Installing and Removing Power Components
How to Install or Remove Fixed Configuration Power Components
Figure 2-13 Fixed Configuration AC Wye Rectifier
4
1 | OT LLM | AC |
|
|
CB | FLT POWER |
| ||
TMP | FAIL |
| ||
|
|
| OK |
|
2 |
|
|
|
|
| 3 |
|
|
|
1 | Power switch |
| 3 | Handle |
2 | Module air filter |
| 4 | Captive screws |
122286
Prerequisites
Before performing this task, make certain that the PDU has been installed and any cosmetic covers removed.
Required Tools and Equipment
You need the following tools to perform this task:
•
•
Steps
To remove a DC PEM or AC rectifier, perform the following steps:
Step 1 Attach the
Step 2 On the front side of the chassis, pull the power tab on the bottom front of the DC PEM or AC rectifier out to the off position.
Step 3 Use the screwdriver to loosen the two captive screws on the front of the DC PEM or AC rectifier.
Step 4 Grasp the DC PEM or AC rectifier handle and pull the DC PEM or AC rectifier halfway from the bay. Be sure to pull the module by the handle only.
Caution Take care when handling a DC PEM or AC rectifier that has been recently
Cisco CRS Carrier Routing System
|
| |
|