Chapter 2 Installing and Removing Power Components
How to Install or Remove Modular Configuration Power Components
Removing AC Power Cords or DC Power Shelf Wiring
This section describes how to remove the DC input wiring, DC terminal block covers and the AC power cords from the Cisco CRS Carrier Routing System
Removing Modular Configuration DC Power Shelf Wiring
This section describes how to remove the DC wiring from the modular configuration DC power shelf. For more detailed information on chassis DC power systems, see the “DC Power Systems” section on page
Figure 2-34 shows the power cable connections at the rear of the modular configuration DC power shelf.
Figure 2-34 Modular Configuration DC Power Shelf Power Cable Connections
281336
Prerequisites
Before performing this task, power down and remove DC PMs in the shelf you want to disconnect.
Note Before removing wiring from the power shelf, make sure that the input power cables are not energized.
Required Tools and Equipment
You need the following tools to perform this task:
•
•
•
Cisco CRS Carrier Routing System
|
| ||
|
|
