Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components

How to Install or Remove a Slot Cover

Figure 4-12 Switch Fabric Slot (Half Height) Slot Cover

122142

Prerequisites

Before performing this task, remove any cosmetic covers and ensure that the slot over which you are about to install the cover is empty. See the “Removing an RP, PRP, or DRP Card” section on page 4-41and the “Removing a Switch Fabric Card” section on page 4-26.

Required Tools and Equipment

You need the following tools and part to perform this task:

ESD-preventive wrist strap

Large Phillips screwdriver

Slot cover

Steps

To install a slot cover, follow these steps:

Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket on the rear (MSC) side or a bare metal surface on the chassis.

Step 2 Using the handle, hold the slot cover in place over the slot.

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

4-14

OL-6256-17

 

 

Page 114
Image 114
Cisco Systems OL-6256-17 manual Switch Fabric Slot Half Height Slot Cover