Cisco Systems OL-6256-17 manual Unscrew Ejectors from PM

Chapter 2 Installing and Removing Power Components

How to Install or Remove Modular Configuration Power Components

Steps

To remove the AC or DC PMs, perform the following steps:

Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.

Step 2 At the front of the chassis, unscrew the ejectors from the PMs, as shown in Figure 2-32.

Figure 2-32 Unscrew Ejectors from PM

CISCO CRS-1

LINECARD CHASSIS

1

254847

1

Ejector on PM

Step 3 After unscrewing the ejector, carefully slide the PM out of the power shelf, as shown in Figure 2-33.

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

OL-6256-17 2-43