
Chapter 3 Installing and Removing Air Circulation Components
How to Install or Remove Air Circulation Components
Steps
To install a power module air filter, follow these steps:
Step 1 Attach the
Step 2 Place the screwdriver under the edge of the air filter
Step 3 Gently pry the holder loose with the screwdriver; it should pop off easily.
Step 4 Place the air filter in position on the front of the power module.
Step 5 Place the holder in position on the front of the power module over the air filter.
Step 6 Press the holder firmly but gently until it snaps into place.
What to Do Next
After performing this task, replace the front cover plates.
Removing a Power Module Air Filter
This section describes how to remove a power module air filter. For further information, see the “About Line Card Chassis Airflow” section on page
Each power module has a serviceable air filter that is attached to the front of the power module and is held in place by an air filter
Prerequisites
Before performing this task, you must first remove any front cover plates.
Caution Never operate the Cisco CRS
Required Tools and Equipment
You need the following tools to perform this task:
•
•Medium
Cisco CRS Carrier Routing System
|
| ||
|
|