Cisco Systems OL-6256-17 manual Installing the Front Cover, Front Cover Installed on Chassis

Chapter 5 Installing and Removing Exterior Components

Installing or Removing the Front Side Exterior Components

What to Do Next

Be sure that all parts have been carefully set aside and repackaged appropriately. If you have ordered the front cover for the 8-slot chassis, proceed to the next section for installation instructions.

Installing the Front Cover

This section describes how to install the front cover. The front cover protects the card cage on the front (PLIM) side of the chassis.

Figure 5-5shows the front cover installed on the Cisco CRS 8-slot line card chassis.

Figure 5-5 Front Cover Installed on Chassis

CISCO CRS-1

LINECARD CHASSIS

254852

Prerequisites

Before installing the front cover, you should mount the chassis in a rack and remove the rear handle pulls. See Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Unpacking, Moving, and Securing Guide.

Required Tools and Equipment

•ESD-preventive wrist strap

•Large Phillips screwdriver

•Front cover (Cisco product number: CRS-8-FRONT-COVER=)

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

OL-6256-17 5-9