Chapter 2 Installing and Removing Power Components
How to Install or Remove Fixed Configuration Power Components
Prerequisites
Before performing this task, remove any front cosmetic covers.
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
•Fixed configuration PDU
–AC Wye PDU Cisco product number
–AC Delta PDU Cisco product number
–DC PDU Cisco product number
Steps
To install a PDU, perform the following steps:
Step 1 Attach the
Step 2 Make sure that the PDU is unplugged.
Step 3 Grasp the PDU by the side and set it carefully into place in a PDU slot on the rear (MSC) side of the chassis. Be sure to lift the PDU over the lip on the edge of the chassis, and align the guide pins on the chassis with the guide holes on the PDU.
Caution Do not lift the PDU by the power
Step 4 If needed, put the second PDU into place in the other PDU slot on the chassis.
Note The PDU holding plate bolts to both PDUs and the side of the interior of the chassis.
Step 5 Install the PDU holding plate.
a.Slide the holding plate into place on top of the PDU, using the guide bolts on the side of the chassis to place it correctly.
b.Use the socket wrench to bolt the holding plate to the top of the PDUs with the eight
c.Use the socket wrench to bolt the holding plate to the interior of the side of the chassis with the four
Step 6 Use the socket wrench to install the
Cisco CRS Carrier Routing System
|
| |
|
