
Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove an MSC, FP, or LSP
Figure 4-24 Removing a Line Card
1
2
3
122922 |
1 Captive screw | 3 Direction of installation or removal |
2Ejector lever
Step 1 Attach the
Step 2 Use a screwdriver to loosen the captive screw next to each MSC ejector lever.
Caution To prevent ESD damage, handle a line card by its ejector levers or the card carrier edges only. Do not touch any of the electrical components, pins, or circuitry.
Step 3 Simultaneously pivot the ejector levers away from the faceplate to release the line card from the midplane connectors.
Step 4 Grasp the cable management bracket and gently pull the line card halfway from the slot. Step 5 Move one hand under the line card to guide it.
Avoid touching the line card printed circuit board, components, or any connector pins. Do not lift cards by the cable management
Cisco CRS Carrier Routing System
|
| ||
|
|