Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove an MSC, FP, or LSP
Step 6 Place the removed line card on an antistatic mat, or immediately place it in an antistatic bag if you plan to return it to the factory.
Step 7 If the MSC slot is to remain empty, install an MSC impedance carrier to keep dust from the chassis and maintain proper airflow through the MSC compartment.
Step 8 Use a screwdriver to tighten the captive screws next to each impedance carrier ejector lever to ensure proper EMI shielding and to maintain proper airflow throughout the chassis.
What to Do Next
If you did not place the line card in an antistatic bag, do so now for storage and future use.
Verifying the Installation of an MSC, FP, or LSP
This section describes how to verify that a line card has been properly installed.
Figure 4-25 is an illustration of the MSC-140G front panel.
Figure 4-25 CRS-MSC-140G Front Panel
INSTALL
THIS SIDE
UP
1
2
1 | Status LED | 2 | Alphanumeric LEDs |
|
|
|
|
Figure 4-26 shows the FP-140 FP face panel.
Figure 4-26 CRS-FP140 Front Panel
INSTALL
THIS SIDE
UP
1
2
1 | Status LED | 2 | Alphanumeric LEDs |
|
|
|
|
249639
249638
Cisco CRS Carrier Routing System
|
| |
|
