Table 1 | Changes to This Document (continued) | ||
|
|
|
|
Revision |
| Date | Change Summary |
|
|
| |
July 2011 | Added information about new | ||
|
|
| Processor (LSP) card to the following sections: |
|
|
| • Chapter 1, “Cisco CRS Carrier Routing System |
|
|
| Line Card Chassis Overview” |
|
|
| • Chapter 4, “Installing and Removing Line Cards, PLIMs, |
|
|
| and Associated Components” |
|
|
| • Appendix A, “Cisco CRS Carrier Routing System |
|
|
| Line Card Chassis Specifications” |
|
|
| |
July 2011 | Added new modular configuration AC cord clamp. Updated | ||
|
|
| Appendix A and added Appendix B. Minor editorial and |
|
|
| technical changes were also made. |
|
|
| |
April 2011 | Added information about new | ||
|
|
| |
|
|
| Technical updates and minor editorial changes were also |
|
|
| made. |
|
|
| |
November 2010 | Updated grounding and modular configuration power | ||
|
|
| sections. Minor editorial and technical changes were also |
|
|
| made. |
|
|
| |
October 2010 | Added information about the new MSC140 and FP140 line | ||
|
|
| cards; |
|
|
| |
|
|
| CFP PLIM. Minor editorial and technical changes were also |
|
|
| made. |
|
|
| |
September 2010 | Added new procedures on installing and removing modular | ||
|
|
| configuration power components to Chapter 2, “Installing |
|
|
| and Removing Power Components.” |
|
|
| |
Jan 2010 | Added installation of rear exhaust screen. | ||
|
|
| |
May 2008 | Added new procedures on installing and removing a pillow | ||
|
|
| block to Chapter 4, “Installing and Removing Line Cards, |
|
|
| PLIMs, and Associated Components.” |
|
|
| |
February 2008 | Minor technical changes. | ||
|
|
| |
August 2007 | Updated the document with technical corrections. Also added | ||
|
|
| procedures in Chapter 5, “Installing and Removing Exterior |
|
|
| Components,” on installing the updated inlet grille. |
|
|
| |
October 2006 | Updated the document with technical corrections. Also added | ||
|
|
| procedures in Chapter 5, “Installing and Removing Exterior |
|
|
| Components,” on installing and removing the front and rear |
|
|
| doors, installing and removing the inlet and exhaust grilles, |
|
|
| and added procedures for changing the location of the door |
|
|
| hinge and adjusting the width of the chassis doors if the doors |
|
|
| do not latch properly. |
|
|
|
|
Cisco CRS Carrier Routing System
| xvi |
| |
|
|
