Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components
How to Install or Remove a Slot Cover
Figure 4-11 Cable Management Bracket
How to Install or Remove a Slot Cover
This section contains the following procedures:
•Installing a Slot Cover, page 4-13
•Removing a Slot Cover, page 4-15
Installing a Slot Cover
This section describes how to install a slot cover in the Cisco CRS 8-slot line card chassis. The chassis is shipped with slot covers over the switch fabric card and RP card slots; we advise installing slot covers over any empty slots in the chassis. Both slot cover types are installed in the same manner. (Figure 4-12shows a switch fabric slot cover for reference.) For more detailed information on the slot covers, see the “Information About Impedance Carriers and Slot Covers” section on page 4-6.
Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
