Chapter 2 Installing and Removing Power Components
How to Install or Remove Modular Configuration Power Components
Installing AC Power Cords or DC Power Shelf Wiring
This section describes how to install the DC input wiring, DC terminal block covers and the AC power cords on the Cisco CRS Carrier Routing System
Installing Modular Configuration DC Power Shelf Wiring
This section describes how to wire the modular configuration DC power shelf. For more detailed information on chassis DC power systems, see the “Modular Configuration DC Power” section on page
Figure 2-26 shows the power cable connections at the rear of the modular configuration DC power shelf.
Figure 2-26 Modular Configuration DC Power Shelf Power Cable Connections
281336
Caution When wiring the power shelf, be sure to attach the chassis ground cable to the chassis first and tighten the nuts to a torque of 30
Cisco CRS Carrier Routing System
|
| ||
|
|