Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components

How to Install or Remove a Switch Fabric Card

Prerequisites

Before performing this task, remove any front cover plates.

Caution Removing more than one switch fabric card at a time can misalign the chassis and may damage the card or chassis when reinserting the cards. Remove and reinsert only one card at a time.

Required Tools and Equipment

You need the following tools to perform this task:

ESD-preventive wrist strap

Large Phillips screwdriver

Steps

To remove a switch fabric card, see Figure 4-20and follow these steps:

Figure 4-20 Removing a Switch Fabric Card

1

3

2

122921

1 Captive screw

3 Direction of installation or removal

2Ejector lever

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

 

OL-6256-17

4-27

 

 

 

Page 127
Image 127
Cisco Systems OL-6256-17 manual Before performing this task, remove any front cover plates