Chapter 5 Installing and Removing Exterior Components
Installing or Removing the Front Side Exterior Components
Steps
To install the inlet grille, perform the following steps:
Step 1 Remove the new inlet grille from its packaging, then set the packaging aside.
Step 2 Attach the
Step 3 Align and insert the hooks at the bottom of the inlet grille into the cutouts at the bottom of the chassis casing on the front (PLIM) side of the chassis, just in front of the power modules.
Step 4 Rotate the top of the inlet grille toward the chassis, and snap it into place on the ball studs.
What to Do Next
After performing this task, you may power on the chassis. See Chapter 2, “Installing and Removing Power Components.”
Removing the Inlet
This section describes how to remove the inlet grille from a Cisco CRS
Prerequisites
No prerequisites exist for this task.
Required Tools and Equipment
You need the following tools to perform this task:
•
Steps
To remove the inlet grille, perform the following steps:
Step 1 Attach the
Step 2 While facing the front (PLIM) side of the chassis, firmly grasp the top outside edges of the inlet grille. Step 3 Pull the top of the grille firmly away from the chassis; it loosens from the connecting ball studs.
Step 4 Slide the hooks at the bottom of the grille free of the cutouts at the bottom of the chassis casing. Step 5 Carefully set the inlet grille aside.
Cisco CRS Carrier Routing System
|
| |
|
