Chapter 2 Installing and Removing Power Components

How to Install or Remove Modular Configuration Power Components

Figure 2-36 Removing Cord from Cord Clamp

1

3

4

2

1

3

4

2

209331

1

Cord Clamp

3

Screw that secures the cord in clamp

 

 

 

 

2

Cord removed from clamp

4

Screwdriver that loosens screw

 

 

 

 

Note In Figure 2-36, the AC cord clamp shown on the left was available until June 2011, and the AC cord clamp shown on the right is available since June 2011. The location of the screw that secures the cord in the cord clamp is different.

What to Do Next

After you remove the DC wiring and DC terminal block covers or AC cords, remove the power shelf. See the “Removing a Modular Configuration Power Shelf” section on page 2-48.

Removing a Modular Configuration Power Shelf

This section describes how to remove a modular configuration power shelf from the Cisco CRS 8-slot line card chassis.

Although there are differences between the AC and DC power shelves, they are removed in the same manner.

Prerequisites

Before performing this task, remove DC input power wiring or AC input cords from the shelf that you want to disconnect. For more information, see the “Removing AC Power Cords or DC Power Shelf Wiring” section on page 2-45.

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

2-48

OL-6256-17

 

 

Page 80
Image 80
Cisco Systems OL-6256-17 manual Removing a Modular Configuration Power Shelf, Removing Cord from Cord Clamp