Chapter 4 Installing and Removing Line Cards, PLIMs, and Associated Components

How to Install or Remove an RP, PRP, or DRP PLIM

Verifying the Installation of an RP, PRP, or DRP Card

This section describes how to verify and troubleshoot the installation of a route processor (RP) or distributed route processor (DRP) card in the Cisco CRS 8-slot line card chassis. For more detailed information on the RP card, see Cisco CRS Series Carrier Routing System 8-Slot Line Card Chassis System Description.

This section describes how to verify that the card has been properly installed. Status indicators on the RP front panel include:

Alphanumeric LED display

Status OK LED

Active/Standby LED

Figure 4-29shows the RP card front panel.

Figure 4-29 RP Card Front Panel

1

2

3

4

5

6

7

8

9

10

11

12 13

209143

1

Console port

6

Control Ethernet 0 port

11

Alphanumeric LEDs

 

 

 

 

 

 

2

AUX port

7

Control Ethernet 1 port

12

PRIMARY LED

 

 

 

 

 

 

3

Alarm connector

8

PC card slot

13

STATUS LED

 

 

 

 

 

 

4

Alarm LED array

9

EXT CLK 0 port

 

 

 

 

 

 

 

 

5

Management Ethernet port

10

EXT CLK 1 port

 

 

 

 

 

 

 

 

Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide

 

OL-6256-17

4-43

 

 

 

Page 143
Image 143
Cisco Systems OL-6256-17 manual Verifying the Installation of an RP, PRP, or DRP Card, Status LED