Cisco Systems OL-6256-17 manual Troubleshooting the Plim

Contents

			Steps	4-49
			What to Do Next			4-51
			Removing a PLIM		4-51
			Prerequisites		4-51
			Required Tools and Equipment				4-52
			Steps	4-52
			What to Do Next			4-54
			Verifying the Installation of a PLIM				4-54
			Troubleshooting the PLIM 4-54
			How to Install or Remove a Small Form-Factor Pluggable (SFP) Module						4-55
			Installing a Bale-Clasp SFP Module				4-55
			Prerequisites		4-55
			Required Tools and Equipment				4-55
			Steps	4-55
			What to Do Next			4-56
			Removing a Bale-Clasp SFP Module				4-56
			Prerequisites		4-57
			Required Tools and Equipment				4-57
			Steps	4-57
			What to Do Next			4-58
			Replacing a SFP on a Line Card that Uses an Articulated Bracket						4-59
			Installing and Removing Exterior Components
C H A P T E R 5								5-1
			Overview of the Exterior Components				5-1
			Installing or Removing the Front Side Exterior Components 5-1
			Removing the Cable Management Bracket					5-2
			Prerequisites		5-2
			Required Tools and Equipment				5-2
			Steps	5-2
			What to Do Next			5-3
			Reinstalling the Cable Management Bracket					5-3
			Prerequisites		5-4
			Required Tools and Equipment				5-4
			Steps	5-4
			What to Do Next			5-4
			Installing the Inlet Grille—Fixed Configuration Power Supply 5-5
			Prerequisites		5-5
			Required Tools and Equipment				5-5
			Steps	5-6
		Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide
	x								OL-6256-17